Parameter

Description

Cut Lines

Sets the positions (pixel values) for the section lines using the X/Y/Z sliders or input fields.
Alternatively you can also adjust the positions directly in the image area. To adjust the positions, move the mouse over a section line in the image. Hold down the left mouse button and move the mouse.

-

Mid

Positions the relevant slider at the center of the view.

Line Width

Only visible if the Show All mode is activated.
Enter the thickness of the section lines in pixels using the sliders or input fields. This results in a maximum intensity projection being displayed over the selected pixel width.
You can also adjust the width directly in the image area. To adjust the width, move the mouse over a section line in the image until a small arrow is displayed. Hold down the left mouse button and move the mouse.

Cut Line Opacity

Only visible if the Show All mode is activated.
Here you can enter the degree of opacity of the section lines from 0% (invisible) to 100% (completely opaque).

Views

Only visible if the Show All mode is activated.
Sets the number and allocation of views in the Image View.

-

Displays four views.

-

Displays one view.

-

Displays two vertically separated views.

-

Displays two horizontally separated views.

-

Displays three vertically separated views.

-

Displays three horizontally separated views.