1. In the Tiles tool open the Focus Surface and Support Points section.
2. Go to the Global (on Carrier) tab.
3. All the support points of the selected sample carrier template are displayed in the Support Points list.
3. Click on the Verify button.
4. The Verify Global Support Points dialog opens.
4. Select the Helper Method you want to use. This will support you in determining the z-values. The options are Autofocus (AF) and Definite Focus (DF). If you have neither then you can only adjust z-values manually.
5. Click on Move To Current Point.
6. The stage automatically moves to the support point that is highlighted in the list. Alternatively, you can also double-click on the support point in the list.
6. In the Live mode use the Focus (or SW Autofocus) tool to set the z-value.
7. Click on Set Z and Move to Next.
8. The support point is marked with a check mark.
9. The stage automatically moves to the next support point in the list.
8. Repeat the last 3 steps until you have checked all the support points.
9. The message All points have been verified appears.
9. Close the Verify Global Support Points dialog.

1. You have adjusted and verified the Z-values of all support points.