This step is helpful if some tiles or regions of interest are blurry. These tiles/regions can be replaced by repeating the acquisition of the selected tiles or tile images. The procedure is as follows:

  • Select all blurry tiles first.
  • Adjust the focus for each tile position.
  • Take new images.

Parameter

Description

Select Tiles

If this mode is active, you can select the tiles which you want to re-shoot.

Use the Z-Position slider under Dimension tab or the arrows within the Image area to scroll through the acquired images.

If you found a tile image that you want to re-shoot, simply click on it. Then the color of the image frame turns from red to green.

Note that all tiles or blurry regions have to be defined before the image acquisition can be repeated.

Acquire

If this mode is active. you can acquire the selected tiles again after the focus was adjusted manually.

If you click on this button, the stage will move to the first tile and the following buttons will appear:

-

Snap

Acquires a new image.

-

Replace

Replaces the old tile by the new tile.

-

Correct Brightness

In case the tile is brighter or darker, here you have the possibility to adapt the brightness of the tiles image.

Click Finish to exit the wizard.