1. You have read the chapter Configure security software attentively.
2. You have opened the ZEISS Microscopy Installer with admin rights and you are logged in.
3. Your system is connected to the Internet.
4. You have selected (default setting) the online installation, see ZEISS Microscopy Installer manual.

1. Open the Install tab.
2. Go to ZEN Core / ZEN starter > Third Party Hardware Drivers and activate Basler Pylon for Visioner.
3. Activate I agree to the Terms and Conditions of the selected software.
4. Click Install.
5. The selected components are downloaded and installed. A progress bar shows the current status.
6. A Welcome dialog is displayed.
   
5. Activate I agree to the pylon Terms & Conditions, and click Next.
6. The Profiles dialog is displayed.
   
6. Click Custom, and click Next.
7. The Features dialog is displayed.
   
7. Activate the following features:
   - pylon Runtime > pylon Core Runtime
   - USB Camera Support
   - Firmware Updater
   Click Next.
8. The Destination Folder dialog is displayed.
   
8. Click Next.
9. The Ready to Install dialog is displayed.
   
9. Click Install.
10. The installation starts. The Installation dialog is displayed.
    
10. Wait until installation has finished.
11. The following dialog is displayed.
    
11. Click Close.

1. You have installed the Pylon USB3 Vision driver.