Parameter

Description

Reference Image

Only visible if you have created a second reference image after the spot experiment.
Selects which reference image is displayed int the view.

–

Pre-Experiment

Displays the reference image acquired before the experiment.

–

Post-Experiment

Displays the reference image acquired after the experiment.

Display Chart

Selects which chart is displayed above the correlation chart.

–

Count Rate

Displays the count rate chart.

–

Residuals

Displays the residuals chart. Note that the residuals chart only contains information after a fit was executed for the respective spot.

Filter

–

Detrending

Activated: Applies a detrending filter to remove the trend (e.g. due to the photo bleaching) from the experiment data. Detrending is calculated by a low-pass filter with the filter time constant provided with the input field.

–

Dust

Activated: Applies a dust filter to remove high intensity peaks (caused e.g. by aggregated objects) from the experiment data and sets the parameter with the input field. Dust is considered, if the average intensity multiplied with the parameter value is higher than the mean signal intensity.

Fit Model

Selects the fit model for the correlation curve.

–

1 Component 2D

Selects the one component 2D model.

–

2 Component 2D

Selects the two component 2D model.

–

1 Component 3D

Selects the one component 3D model.

–

2 Component 3D

Selects the two component 3D model.

–

1 Component Anomalous 2D

Selects the one component anomalous 2D model.

–

1 Component Anomalous 3D

Selects the one component anomalous 3D model.

–

Fit

Applies the fit model to the currently selected position/curve.

–

Fit All

Applies the fit model to all positions/curves.

Amplitude Normalization

–

Activate

Normalizes the amplitude to 1.

–

Deactivate

Applies no normalization.

ωr Calibration

Selects which ωr should be used for the fit of the curves.

–

Default

Uses the default setting for the ωr calibration.

–

Custom

Opens a browser to select a file with a user generated ωr calibration. This file can be created with the ωr tab.