Settings based on image view

Note that during the setup of the analysis (via Edit Image Analysis Setting), the segmentation is only performed on the area visible in the viewport. Therefore, if you adapt the region filter by clicking on the objects displayed in the viewport, and select objects that are cut by the current viewport, these objects will only be segmented partially. The region filter will only be adapted based on the part of the object that is in the viewport. In case you want to select objects that exceed the viewport, we suggest to adapt the region filter values manually.

If you enter the analysis wizard via Start Interactive Analysis, the image will be fully segmented during the segmentation step, and therefore it is possible to adapt the region filters by clicking on the objects in the image.

In this step you can define the region filter conditions under which you want an object to be measured.

Parameter

Description

Execute

Activated: Uses the region filters when the measurement program is run.

Interactive

Activated: The region filters can be changed while the analysis setting is run with Start Interactive Analysis.

Classes

Selects the class for which you want to define the conditions.

Select Features

Opens the editor to select region filters.

Copy to All

Copies the defined region filters to all classes.

Region Filters

If you have defined one or more blocks with region filters in the Region Filter Editor, you can select the block for which you want to set the filter.
Select the relevant block and set the maximum/minimum values either by clicking on the objects in the image you want to include in the measurement, or by entering the maximum/minimum values separately.

Undo

Undoes the last change made to the condition.

Redo

Restores the last undone change to the condition.

Reset

Resets all settings for the conditions.