The Illig Workflow generates a joint result from previously performed job runs and consists of two phases:

• Preparation phase:
  Generates results for the Illig workflow, see steps 1-4 below.
• Illig calculation phase:
  Summarizes several job results for calculation of the Illig value, see step 5 below.

1. Select Job Mode > job template with VDA 19.1 or ISO 16232 Method Extended Analysis.
   NOTICE! Don't modify the length size classes because the Illig calculation uses a predefined size classification.
2. Load the input form Technical Cleanliness (Illig Value).
   NOTICE! The sample location and sedimentation time are automatically read-out and applied by executing the Illig job template Technical Cleanliness (VDA 19.2 Joint Result).
3. Run the pre-configured Component Cleanliness job template to analyze your particle traps.
4. Repeat steps 1-3 until all particle traps are analyzed.
5. Perform calculation of the Illig value by using the job template Technical Cleanliness (VDA 19.2 Joint Result).