Step 1: Input Form
In the Form Selection tool, a specific Illig form is provided. The specimen form is part of a loop. This step is iterated with Continue until the last loop iteration is reached. Exit Loop activates the next step.
- To choose the corresponding customer, in the Customer field, click in the table to add the selected customer data.
- The form is displayed in the report.
Step 2: Result Table Loading
In the Load Table from Archive tool, select length classification tables from the job results in the archive for Illig value processing.
Note that you can only use the results of the standards VDA 19.1 Standard Analysis and VDA 19.1 Extended Analysis - Free Analysis.
- Select length classification tables from the job results in the archive. You can add up to 10 tables, see Load Table from Archive Tool.
Step 3: Illig Calculation
Joint results are displayed in a table in the Center Screen Area.
- Enter the relevant data, see Illig Calculation Tool.
Step 4: Reports
Creates a report document for each specimen. The oil report template is pre-selected.
- Inspect for the selected standards the results for particle classification, approval status (if defined) and particle load.
- See particle images of the largest particles per type.
- You can print the report.
See Reports.
After performing the workflow, you have the following options:
- Save and Close
- Save and Repeat
- Close Without Saving
- Repeat Without Saving