In the Size Distribution view, you can check and, if necessary, change the results of the particle typification. Optionally, you can click the Opens the Edit View icon on the gallery image to open the Edit view and change the type there.

1. You run TCA either with image files or you acquire the images within the workflow.
2. You are in the Size Distribution view.

1. In the Image Gallery each particle is displayed in a picture frame containing particle information and interactive elements:
   
   On top of the picture frame, the following information about the particle is displayed: Length, Width, Area, and the type of the particle, e.g. metallic-shiny (M).
   Hover with your mouse over the picture frame of the particle of interest.
2. On the bottom, the icon bar M, N, F, and A is displayed to enable changing the particle type.
2. To display additional information, hover with your mouse over the image.
3. The particle image is shown zoomed out, the particle ID and X and Y particle coordinates are displayed on top of the zoomed out image.
3. In the Image Gallery, in the image, click the desired icon on the bottom to change the particle type or revise an object as artifact. Repeat this step if needed.
4. The gallery image is marked by a red dot on the top left side to indicate a planned change of the particle type.
   
4. Click Apply.
5. The red dot disappears, the image gallery is updated, and the statistics is recalculated accordingly. This also happens, when you click Next to proceed.

1. You have changed the particle type.

See also

• Editing Particle Analysis Results in the Particle Edit View